FIBREGLASS MESH

Fibreglass Mesh is a German manufactured fibreglass mesh.
Fibreglass Mesh is suitable to reinforce substrate stress points such as butt joints, slip joints, lintels, etc for internal gypsum and external adhesive renders.
In the case of 4•5mm bre-cement sheet and polystyrene breglass mesh must be used over the entire area to be plastered.

Application
Fibreglass Mesh is embedded wet-in-wet into mineral renders by trowel. After installation, subsequent coatings can be applied once the bedding coat is fully dry.
• Fibreglass Mesh must be cut with sharp scissors or knife – do not tear.
• Fibreglass Mesh must not be stretched or pulled during handling or installation.
• Fibreglass Mesh is installed only by wet-in-wet embedding into mineral coatings and must not be nailed or stapled to the substrate.
• Where extra lengths of Fibreglass Mesh are required this must be overlapped by at least 100mm.
• See Technical Information sheets for PT 200, PT 300, PT 320, PT 325, PT 351 and PT 400/451 for application specifications on relevant substrate.

Technical
Fibreglass Mesh is alkaline resistant
Weave: LENO
Ends: 3.2/cm
Picks: 1.6/cm
Weight: 160g/m2
Warp: 1360 DTEX Glass
Tensile: 1020 N/50mm
Extension: 3.8%
Weft: 2720 DTEX Glass
Tensile: 1035N/50mm

Extension: 3.8%
Adhesive: AR Binder
Width: as nominated

Storage
Fibreglass Mesh is supplied in 50m rolls of the following widths:
Hard Mesh Soft Mesh
1m x 50m 100mm x 50m
75mm x 50m 200mm x 50m
Fibreglass Mesh can be stored indefinitely.

Service
At the forefront of plastering technology, Putztechnik Products offers its assistance and experience in the selection and use of our products and machines.

BACK